Want to Publish your original paper on IJCRCST, Email to: editor@ijcrcst.com


Author Guidelines


IJCRCST invites you to submit papers for publication will be based on their relevance, clarity, topicality and originality, the extent to which they advance knowledge, understanding and application and their likely contribution towards inspiring further development and research.

Please conform to the following guidelines:

The manuscript should be prepared in English using ?MS Word? with 0.75 inch margin on Top and Bottom sides , 0.5 inch margin on Left and Right sides of the page. ?Times New Roman? font should be used. The font size should be of 10pt but main Title should be of 12pt bold uppercase, main headings should be of 12pt uppercase, subheadings should be of 12pt bold lowercase. Manuscript should be concisely typewritten in 1.15 spaces in A4 sized sheets. The pages shall be numbers consequently. The length of Review/Science Education article should not exceed 20 manuscript pages to include figures, tables and references. No abbreviations on acronyms shall be used in the titles or Abstract acronyms except for measurements. There shall not be decorative borders anywhere in the text including the title page.

I. ARTICLE TITLE:

The title must be as brief as possible, comprehensive and descriptive. It should not be more than 20 words. Title should be of 16 pt uppercase Calibri Font. It should be bold typed, centered and fully capitalized

II. AUTHOR NAMES :

The author (s) full name, designation, department, university or organization, city , state , country, and email. It should be 10-point Calibri Font. It must centered underneath the title of paper.

III. ABSTRACT :

The abstract should present the novelty of the study. Try to keep the abstract below 250 words. Do not make references nor display equations in the abstract. It should mention the techniques used without going into methodological detail and should summarize the most important results. All the three categories, Review Articles, Original Research papers and Short Communications should have an Abstract. It should be 10 pt Calibri Font.

KEYWORDS:

Provide up to 3-6 keywords that express the article contents. Keywords must be alphabetical order, separated by comma. It should be 10pt Calibri Font, Bold and Italic

IV. INTRODUCTION:

The introduction of the paper should explain the background of the problem, relevant literature, intention, and the contribution of the paper to understand and evaluate the results of the present study. The contents of each section June be provided to understand easily about the paper.

V.MATERIALS AND METHODS:

The section should contain adequate technical information about the material and the statistical, analytical and experimental method/ procedures used.. Procedural detail that has been published previously should be referred to by reference. This part should be as clear as possible to enable other scientists to repeat the research presented.

VI.RESULTS AND DISCUSSION:

Results should be explained as sketchily as potential in one of the following ways: text, table(s), or figure(s). The reproducibility and statistical consequence of measurements, material or biological data, must be included where relevant. The Discussion should provide an interpretation of the results and their significance with regard to previously published work. There should not be any significant repetition of the experimental procedures or reiteration of the introduction. Figures should be numbered consecutively with Arabic numerals (i.e. Figure 1, 2, 3 etc.). Provide a brief title with each figure. All figures should be cited in the text. File formats accepted are Microsoft Word (figures must be a single page), PowerPoint (figures must be a single page), PNG, JPEG, TIFF, BMP, CDX (ChemDraw) or TGF (ISIS/Draw). Tables should be numbered consecutively (Table 1, Table 2 etc) and each table must start on a separate page at the end of the manuscript. Each table must have a title. Each table legend, in paragraph form, should briefly describe the content and define any abbreviations used. If values are cited in a table, the unit of measurement must be stated.

VII. CONCLUSION:

A conclusion section must be clearly summarized the advantages, limitations, and possible applications of the paper. Although a conclusion may review the main points of the paper, do not replicate the abstract as the conclusion. A conclusion might elaborate on the importance of the work or suggest applications and extensions.

VIII.REFERENCES:

Referencing is a standardized way of acknowledging the sources of information and ideas that you have used in your research work and which allows the sources to be identified. It is important to be consistent when you are referencing. Each reference is referred to in the text by a number enclosed in a square bracket (i.e., [3]). References must be numbered and ordered according to where they are first mentioned in the paper, not alphabetically.

Journal Papers:

[1] M.Chitra,A.Riyasri "Application of Green - Cloud Computing", International Journal of Computer Science, 18(2), 2014, 112-116.

Books:

[2] Thomas Erl, Ricardo Puttini, Zaigham Mahmood, Cloud Computing: Concepts, Technology & Architecture (Prentice-Hall, 2013).

Theses:

[3] K.Dhilip, Theory and implementation of Ant Colony algorithm in Grid Computing, doctoral diss., Madras Institute of Technology, Channai, TN, 2011.

Proceedings Papers:

[4] W.J. Book, Modeling design and control of flexible manipulator arms: A tutorial review, Proc. 29th IEEE Conf. on Decision and Control, San Francisco, CA, 1990, 500-506

Get in Touch

  • Phone:
    +91 -8973 378 618
    +91 -9659 284 868
    +91 -4288 284 868
  • Email:
    editor@ijcrcst.com
  • Address:
    ExtroMind Publications,
    #2/358,Murugan Plaza,
    Syndicate Bank Upstairs,
    Salem Main Road,
    Tiruchengode,
    Tamilnadu, India-637 211.